Quick Start Guide

8
● If the equipment is used in a manner not specified
by the manufacturer, the protection provided by
the device may be impaired.
● We recommend you send the device back for
calibration once a year, and please contact the
local dealer for the information on maintenance
points.
Using Environment
● DO NOT expose the device to extremely hot, cold,
dusty, corrosive, saline-alkali, or damp
environments. Make sure the running
environment meets the requirement of the
device. The operating temperature shall be -10 °C
to 50 °C (14 °F to 122 °F), and the operating
humidity shall be 95% or less.
● This device can only be safely used in the region
bel
ow 2000 meters above the sea level.
● Place the device in a dry and well-ventilated
environment.
● DO NOT expose the device to high electromagnetic
radiation or dusty environments.
● DO NOT aim the lens at the sun or any other bright
light.
● When any laser equipment is in use, make sure that
the device lens is not exposed to the laser beam, or
it may burn out.
● The device is suitable for indoor and outdoor
uses,but do not expose it in wet conditions.
● The level of protection is IP 54.
● The pollution degree is 2.
Technical Support
● The https://www.hikmicrotech.com portal will
help you as a HIKMICRO customer to get the most
out of your HIKMICRO products. The portal gives
you access to our support team, software and
documentation, service contacts, etc.
Emergency
● If smoke, odor, or noise arises from the device,
immediately turn off the power, unplug the
power cable, and contact the service center.
Manufacture Address
Room 313, Unit B, Building 2, 399 Danfeng Road,
Xixing Subdistrict,Binjiang District, Hangzhou,
Zhejiang 310052, China
Hangzhou Microimage Software Co., Ltd.
COMPLIANCE NOTICE: The thermal series products
might be subject to export controls in various
countries or regions, including without limitation,
the United States, European Union, United Kingdom
and/or other member countries of the Wassenaar
Arrangement. Please consult your professional legal
or compliance expert or local government
authorities for any necessary export license
requirements if you intend to transfer, export,
re-export the thermal series products between
different countries.