Thermal Image Scope Quick Start Guide 1
English 1. Brief Description The thermal image scope is equipped with high-sensitivity IR detector, and adopts advanced thermal imaging technology, to get clear view in poor visibility or dark environment. It helps to view the target and measure the distance. The device is mainly applied to outdoor scenarios such as hunting, law enforcement, etc. The device can capture snapshots, record videos, and set parameters by T-Vision App after being connected to your phone via hotspot.
4. Install Rail Steps 1. Install the device to the rail as the black arrow shows. 2. Insert and tighten the screws. 3. Tighten the knobs to secure the device. Note: Turn off the device first. Use the non-dust cloth to clean the device base and the rail. 5. Connect Device Steps 1. Turn on the device and make sure the hotspot function is disabled. 2. Lift the cover of data exchange interface. 3. Connect the device and power adapter with a type-C cable to power on the device.
trained in supporting the Product. Trademarks Acknowledgement Other trademarks and logos mentioned are the properties of their respective owners. LEGAL DISCLAIMER TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS MANUAL AND THE PRODUCT DESCRIBED, WITH ITS HARDWARE, SOFTWARE AND FIRMWARE, ARE PROVIDED “AS IS” AND “WITH ALL FAULTS AND ERRORS”. HIKMICRO MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, MERCHANTABILITY, SATISFACTORY QUALITY, OR FITNESS FOR A PARTICULAR PURPOSE.
INFRINGE ON THE RIGHTS OF THIRD PARTIES, INCLUDING WITHOUT LIMITATION, RIGHTS OF PUBLICITY, INTELLECTUAL PROPERTY RIGHTS, OR DATA PROTECTION AND OTHER PRIVACY RIGHTS. YOU SHALL NOT USE THIS PRODUCT FOR ILLEGAL HUNTING ANIMALS, INVASION OF PRIVACY OR ANY OTHER PURPOSE WHICH IS ILLEGAL OR DETRIMENTAL TO THE PUBLIC INTEREST.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. FCC Conditions This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation.
www.recyclethis.info Industry Canada ICES-003 Compliance This device meets the CAN ICES-3 (B)/NMB-3(B) standards requirements. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
away from magnetic interference. Power Supply ● The input voltage should meet the Limited Power Source (5 VDC, 2 A) according to the IEC61010-1 standard. Please refer to technical specifications for detailed information. ● Make sure the plug is properly connected to the power socket. ● DO NOT connect multiple devices to one power adapter, to avoid overheating or fire hazards caused by overload. Battery ● Improper use or replacement of the battery may result in explosion hazard.
● Place the device in a dry and well-ventilated environment. ● DO NOT expose the device to high electromagnetic radiation or dusty environments. ● DO NOT aim the lens at the sun or any other bright light. ● When any laser equipment is in use, make sure that the device lens is not exposed to the laser beam, or it may burn out. Emergency ● If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the power cable, and contact the service center.
UD25400B
