Quick Start Guide
Table Of Contents
- 1. Brief Description
- 3. Install Battery (Page 3 – B)
- 4. Install Rail (Page 4 – C)
- 5. Connect Device (Page 5 – E)
- 3. Akku installieren (Seite 2 – C)
- 5. Schiene installieren (Seite 3 - D)
- 5. Gerät anschließen (Seite 4 – E)
- 3. Installer les piles (page 2 – C)
- 6. Installer le rail (page 3 – D)
- 5. Connecter l’appareil (page 4 – E)
- 3. Instalación de la pila (página 2 - C)
- 7. Instalación con riel (página 3 - D)
- 5. Conexión del dispositivo (Page 4 – E)
- 3. Instalar as pilhas (Página 2 – C)
- 8. Instalar a calha (Página 3 – D)
- 5. Ligar o dispositivo (Página 4 – E)
- 3. Installazione della batteria (Pagina 2 – C)
- 4. Installazione della guida (Pagina 3 – D)
- 5. Collegamento del dispositivo (Pagina 4 – E)
- 3. Instalace baterie (strana 2 – C)
- 5. Instalace kolejnice (strana 3 – D)
- 5. Připojení zařízení (strana 4 – E)
- 3. Inštalácia batérie (strana 2 – C)
- 6. Inštalácia koľajničky (strana 3 – D)
- 5. Pripojenie zariadenia (strana 4 – E)
- 3. Instalowanie baterii (str. 2 – C)
- 7. Instalowanie na szynie montażowej (str. 3 – D)
- 5. Podłączanie urządzenia (str. 4 – E)
- 3. Akkumulátor beszerelése (Oldal: 2 - C)
- 8. Sín felszerelése (Oldal 3 – D)
- 5. A készülék csatlakoztatása (Oldal: 4 – E)
- 3. Instalare baterie (Pagina 2 - C)
- 9. Instalare șină (Pagina 3 - D)
- 5. Conectare dispozitiv (Pagina 4 - E)
- 3. Batterij plaatsen (pagina 2 – C)
- 10. Rail plaatsen (pagina 3 – D)
- 5. Apparaat verbinden (pagina 4 – E)
- 3. Installér batteri (side 2 – C)
- 11. Montér skinne (side 3 – D)
- 5. Tilslut enhed (side 4 – E)
- 3. Installer batteri (side 2 – C)
- 12. Installer skinne (side 3 – D)
- 5. Tilkoble enheten (side 4 – E)
- 3. Asenna paristo (sivu 2 – C)
- 13. Kiskoasennus (sivu 3 – D)
- 5. Yhdistä laite (sivu 4 – E)
- 3. Montering av batteri (sida 2 – C)
- 14. Montering på skena (sida 3 – D)
- 5. Anslutning av enheten (sida 4 – E)
- 3. Установка батареи (стр. 2 – C)
- 4. Установка направляющей (стр. 3 – D)
- 5. Подключение устройства (стр. 4 – E)
- 3. Pilin Takılması (Sayfa 2 – C)
- 15. Rayın Takılması (Sayfa 3 - D)
- 5. Cihazın Bağlanması (Sayfa 4 – E)
- 3.バッテリーの取り付け(2 – Cページ)
- 4. レールの取り付け(3 – Dページ)
- 5.デバイスの接続(4 – Eページ)
- 3. 배터리 설치(페이지 2 – C)
- 16. 레일 설치(페이지 3 – D)
- 5. 장비 연결 (페이지 4 – E)
- 3.安裝電池(第 2 頁—C)
- 17. 安裝導軌(第 3 頁—D)
- 5.連線裝置(第 4 頁—E)
10
APPLICABLE LAW, THE LATER PREVAILS.
Regulatory Information
FCC Information
Please take attention that changes or modification not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
FCC compliance: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum
distance 41.21mm between the radiator and your head.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. T
his device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.