User's Manual

Check-in Required
and Manual
Diagnosis
a. In the live view interface, pull the main trigger to switch to the
opcal
channel.
b. Aim the scanning frame to the QR code. The device will scan the QR
code, and prompt the scanning result.
c. Pull the main trigger again to capture and mark the inspect point
image. You can select Normal, Emergency Defect, Severe Defect,
General Defect, or Pending from
.
Check-in Required
and Aut
o Diagnosis
a. In the live view interface, pull the main trigger to switch to the
opcal channel.
b. Aim the scanning frame to the QR code. The device will scan the QR
code, and prompt the scanning result.
c. Pull the main trigger again, then the device captures and
automacally marks the inspect point image.
Check-in Not
R
equired and
Manual Diagnosis
a. Aim the device to the inspect point.
b. Pull the main trigger to capture and mark the inspect point image.
You can select Normal, Emergency Defect, Severe Defect, General
Defect, or Pending from
Check-in Not
R
equired and Auto
Diagnosis
Aim the device to the target and pull the main trigger, then the device
captures and automacally marks the inspect point image.
5. Save the capture.
Aer compleng the current inspect point check, the device moves on to the next point
automacally. Repeat the step to check other points.
6. Pr
ess
to see the captured image of every inspect point. Change the status if necessary.
Figure 5-2 Check Inspecon Result
What to do next
Upload the r
esults to the PC client aer nishing the route inspecon. See the user manual of
HIKMICRO Inspector for instrucons.
5.3 Upload Inspecon Result and View Report
Upload the inspecon results to the client soware for central management and report
generaon.
Handheld Thermal Camera G Series User Manual
28