User's Manual

Chapter 5 Route Inspecon
In certain situaons that require temperature check for many inspect points, you can use the client
soware to create inspecon routes that cover all the points and send a route inspecon task to
the device. Aer the device examines the temperatures of the inspect points, it uploads the results
to the client soware.
Figure 5-1 Route Inspecon Work Flow
The device receives the tasks from and uploads the inspecon results to the PC client soware by
its WLAN or Hotspot funcon.
5.1 Create Inspecon Route and Send Task to Device
Create the inspecon routes on HIKMICRO Inspector. The client should be connected to the device
be
fore sending the route inspecon task.
Be
fore You Start
Download the HIKMICRO Inspector from
hp://www.hikmicrotech.com and install the program to
y
our PC.
The PC should support WLAN funcon.
Steps
1. Open HIKMICR
O Inspector.
2. Create inspect points and routes. See the user manual of HIKMICRO Inspector for instrucons.
3. Connect y
our device and PC to the same LAN. Available methods as below:
-
Connect your PC and your device to the same Wi-Fi network. For device Wi-Fi connecon, go
to
Sengs → Device Sengs → WLAN to select and connect desired Wi-Fi network. See
Connect Device to Wi-Fi f
or more instrucons.
-
Connect your PC to the device hotspot. Turn on and set up device hotspot by Sengs →
Device Sengs → Hotspot . See
Set Device Hotspot f
or more instrucons.
4. Click De
vice Management to add your device into the client. See the user manual of HIKMICRO
Inspector for instrucons.
5. Go to Task Management → Route Management to select a route and click Apply to Device.
Handheld Thermal Camera G Series User Manual
26