User's Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Symbol Conventions
- Safety Instruction
- Chapter 1 Overview
- Chapter 2 Preparation
- Chapter 3 Display Settings
- Chapter 4 Temperature Measurement
- Chapter 5 Route Inspection
- Chapter 6 Picture and Video
- Chapter 7 Distance Detection
- Chapter 8 Geographic Location Display
- Chapter 9 Direction Display
- Chapter 10 Connect Bluetooth
- Chapter 11 Set LED Light
- Chapter 12 Cast Device Screen to PC
- Chapter 13 Connect Device to Wi-Fi
- Chapter 14 Set Device Hotspot
- Chapter 15 Thermal View Mobile Client Connection
- Chapter 16 Image Local Output
- Chapter 17 Maintenance
- Chapter 18 Appendix
Regulatory Informaon
Note
These clauses apply only to the products bearing the corresponding mark or informaon.
FCC Compliance Statement
Please take aenon that changes or modicaon
not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment. This device complies with
Part 15 of the FCC Rules. Operaon is subject to the following two condions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operaon.
Note: Due to the device size limit, the above statement may not be disclaimed on the device. This
equipment complies with FCC radiaon exposure limits set forth for an uncontrolled environment.
Note: This product has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protecon
against harmful interference in a residenal installaon. This product generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instrucons,
may cause harmful interference to radio communicaons. However, there is no guarantee that
in
terference will not occur in a parcular installaon. If this product does cause harmful
interference to radio or television recepon, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separaon between the equipment and receiver.
—Connect the equipmen
t into an outlet on a circuit dierent from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
EU/UKCA Conformity Statement
This product and - if applicable - the supplied accessories too are marked with "CE"
and c
omply therefore with the applicable harmonized European standards listed
under the EMC Direcve 2014/30/EU, RE Direcve 2014/53/EU, the RoHS Direcve
2011/65/EU
This product and - if applicable - the supplied accessories too are marked with
"UK
CA" and comply therefore with the following direcves: Radio Equipment
Regulaons 2017, Electromagnec Compability Regulaons 2016, Electrical
Equipment (Safety) Regulaons 2016, the Restricon of the Use of Certain
Hazardous Substances in Electrical and Electronic Equipment Regulaons 2012.
Handheld Thermal Camera G Series User Manual
iii










