User Manual

STEP 3
Attach Chair Back Support (cont.)
With your buddies help, line up the holes in the Arm Rest
(A), Chair Back Support (D), and Chair Back (E), and
push Lag Bolt (F) and Metal Washer (I) through as shown
in image #5. Use the pilot hole to ensure that the Lag
Bolt passes through the center of the cross brace. Tighten
the Lag Bolt and repeat on other side.
Helpful Tip
Place the Chair Back
Support (D) into the
middle of the 3 reclining
notches to help keep it in
place as you connect the
3 components with the
Lag Bolt.
Be sure the chair back
support is positioned with
the brace facing outward.
Pilot hole
F
Image #5
Pre-drilled holes
STEP 4
I
Image #7Image #6
H
K
J
I
Attach Front Legs to Seat Base
Insert Plastic Washer (K) into the pre-drilled hole on Seat Base (B), as shown in
image #6. Lift the front of the seat and align the hole with the pre-drilled hole
in the front leg and slide Carriage Bolt (H) through to attach, as shown in image
#7. Note: Holes are pre-drilled for the Carriage Bolt to pass through, but use a
hammer to fi rmly tap the bolt end several times so that the square neck sinks into
the highwood
®
material. Repeat on other side.
Attach Metal Washer (I) and Lock Nut (J) to the carriage bolt from the inside of
seat base and tighten so that it further pulls the bolt neck into the material…
leaving just the dome fl ush with the surface. Repeat on other side.