User Manual

Before you start
This assembly can be done by one person alone, however it is much easier when
two people work as a team. Also, do not over-tighten bolts, but ensure that a fi rm
and secure connection is made in every instance to avoid excess movement in joints.
Seat Base
Take 2 x Plastic Washers (K) and insert one into the
pre-drilled holes on each inside edge of the Seat Base (B)
as shown in image #1.
Image #1
Attach Chair Back Support
Insert 4 x Plastic Washers (K) into their pre-drilled holes in
the Chair Back Support (D) as shown in image #3.
Pilot hole
STEP 1 STEP 3
STEP 2
I
F
K
K
Connect Seat Back to Seat Base
This is where a buddy comes in handy. Position and hold
the Seat Back (E) and Seat Base (B) together, and attach
using a Lag Bolt (F) and Metal Washer (I) as shown in
image #2. Repeat on other side.
The lower brace part of the Seat Back that the Lag
Bolt goes through has a pilot hole to show where the
Lag Bolt should enter. Use a fl ashlight as shown in
image #2 to see down between this brace and the
Seat Base to ensure that the Bolt enters this spot.
(It is important that the Lag Bolt runs through the
center of this brace).
Image #1
Image #3
Image #4
We will now connect the Chair Back Support (D) to the
Arm Rest (A) and Seat Back (E) as shown in image #4.
(Step #3 directions continued on next page).
A
E
D
Image #2
Helpful Tip