User Manual

ASSEMBLY GUIDE

Adirondack Chair

TOOLS

• 7/16" Wrench

(Socket wrench recommended)

• Screwdriver/Square bit #1

(Power screwdriver/Square bit #1

recommended)

• Hammer & Flashlight.

COMPONENTS

Part # Description Qty

(A) Arm Rests with front legs 2

(B) Seat Base 1

(D) Chair Back support 1

(E) Chair Back 1

(F) Lag bolts 4

(G) Wood screws 4

(H) Carriage bolts 2

(I) Metal washers 6

(J) Lock nuts 2

(K) Plastic washers 8

(A)

(E)

(C)

(B)

(F)

(I)

(J)

(K)

(H)

(G)

(D)

PAGE 1
ASSEMBLY GUIDE Adirondack Chair TOOLS • 7/16" Wrench (Socket wrench recommended) • Screwdriver/Square bit #1 (Power screwdriver/Square bit #1 recommended) • Hammer & Flashlight.
PAGE 2
Before you start This assembly can be done by one person alone, however it is much easier when two people work as a team. Also, do not over-tighten bolts, but ensure that a firm and secure connection is made in every instance to avoid excess movement in joints. STEP 1 STEP 3 Seat Base Attach Chair Back Support Take 2 x Plastic Washers (K) and insert one into the pre-drilled holes on each inside edge of the Seat Base (B) as shown in image #1.
PAGE 3
STEP 3 Attach Chair Back Support (cont.) With your buddies help, line up the holes in the Arm Rest (A), Chair Back Support (D), and Chair Back (E), and push Lag Bolt (F) and Metal Washer (I) through as shown in image #5. Use the pilot hole to ensure that the Lag Bolt passes through the center of the cross brace. Tighten the Lag Bolt and repeat on other side.
PAGE 4
STEP 5 Front Leg Support Carefully turn the chair onto its side (on carpet or a soft surface). Note that pilot holes on the inside of chair legs show exactly where leg cross support should be attached as shown in image #7. Using the 4 x Wood Screws (G), screw the Front Leg Cross Support (C) to the rear of the front legs (A) into pilot holes. See image #8.