Installation & Assembly

ASSEMBLY INSTRUCTION
NOTE: Please consult a qualified electrician if you are not certain of the installation.
CAUTION: Before starting the installation, disconnect the power by turni
ng off the circuit breaker or
by removing the fuse in the fuse box. Caulk to mounting surface at top and sides.
1. Fasten the m
ounting screw to crossbar and adjust to desired length. Make sure the thread is facing
outside.
2. Fasten cross bar to the outlet box using 2 outlet box screws.
3. T
ake the ground wire from the house, wrap it around the ground screw on the cross bar so that the
end of the ground wire is still loose, tighten the ground screw, and connect the ground wire from
the fixture to the loose end of the ground wire from the house by twisting the ends together with
pliers. Connect the wires, white-to-white and black-to-black. Cover the connections using the wire
connectors provided.
4. Place the fixture body to the wall by aligning the protruding mounting screw all the way through
the wall pl
ate and tighten the fixture using 2 lock nuts and rubber washers provided. Fasten the
fixture until it held firmly to the wall.
5. Install bulb (not included).
6. T
urn on the power.