User Manual

COUNTERFEIT DETECTION

BILL COUNTER

• UV (Ultraviolet) detection function is used to check all kinds of banknotes

which contain ‘UV’ features.

The ‘UV’ function is automatically turned on by default when the machine is powered

up. It can also be selected or deselected by pressing the ‘UV’ button located in the

function console. If the machine detects a counterfeit note during counting, it will

stop and emit a beeping sound, while the counting display will show the message

‘E-2’ and the ‘UV’ indicator will blink (alerting the presence of a suspicious bill). The

suspicious bill will always be the last one in the stacker. Remove suspicious bill and

press the ’RESTART’ button to continue counting.

PLEASE NOTE: There are 10 levels of ‘UV’ for selection: Hold the ‘RESTART’ button for

5 seconds until the counting display window shows ‘OP-A’ and the ‘BATCH’ display

window shows one digit of the number ’00-10’. Press the ‘–‘ button to select ‘UV’ for

sensitivity as required (the higher the number setting, the higher the ‘UV’ sensitivity).

• MG (Magnetic) detection function is used to check all kinds of banknotes

which contain ‘MG’ features.

The ‘MG’ function is automatically turned on by default when the machine is pow-

ered up. It can also be selected or deselected by pressing the ‘MG’ button, located

in the function console. If the machine detects a counterfeit banknote during count-

ing, it will stop counting and emit a beeping sound, while the counting display will

show the message ‘E-3’ and the ‘MG’ indicator will blink (alerting the presence of a

suspicious bill). The suspicious bill will always be the last one in the stacker. Remove

the suspicious bill and press ‘RESTART’ button to continue counting.

PLEASE NOTE: There are 10 levels of ‘MG’ for selection: Hold ‘RESTART’ button for 5 sec-

onds until the counting display window shows ‘OP-A’ and the ‘BATCH’ display window

shows one digit of the number ’00-10’. Now press the ‘+’ button to select ’OP-B’ in the

counting display window. Press the ‘–‘ button select ‘MG’ sensitivity as required (the

higher the number setting, the higher the ‘MG’ sensitivity).