Technical Data

High Performance Cement by Quikrete
®
www.highperformancecement.com • [phone]
FastSet
™
Concrete Mix
FastSet
™
Concrete Mix
Product No. 1004-68
Product Description
High Performance Cement FastSet
™
Concrete Mix is a high performance
cement high-strength, rapid hardening, pre-blended concrete requiring
only the addition of water.
Product Use
FastSet
™
Concrete Mix is a fast-setting, high early strength concrete
designed to build or repair concrete sidewalks, driveways, highways,
bridge decks, concrete parking lots and concrete floors. Use at any
thickness from 1-1/2” - 24” (38 - 610 mm). FastSet
™
Concrete Mix has
less shrinkage than ordinary Portland cement concrete. FastSet
™
Concrete Mix is also available with an integral corrosion inhibitor. The
addition of corrosion inhibitor has no adverse effect on the other
physical properties of the product.
Size
60 lb (27.2 kg) bags
Yield
Each 60 lb (27.2 kg) bag of FastSet
™
Concrete Mix will yield
approximately 0.45 cu ft (12.6L) of mixed concrete.
Technical Data
APPLICABLE STANDARDS
ASTM International
• ASTM C78 Standard Test Method for Flexural Strength for Concrete
(Using Simple Beam with Third-Point Loading)
• ASTM C39 - Standard Test Method for Compressive Strength of
Cylindrical Concrete Specimens
• ASTM C191 Standard Test Method for Time of Setting of Hydraulic
Cement by Vicat Needle
• ASTM C928 Standard Specification for Packaged, Dry, Rapid-
Hardening Cementitious Materials for Concrete Repairs
PHYSICAL/CHEMICAL PROPERTIES
FastSet
™
Concrete Mix when tested in accordance with ASTM
procedures provides typical results as listed in Table 1. FastSet
™
Concrete Mix meets the requirements of ASTM C928 Type R3. It can
be modified to meet specific requirements of the Department of
Transportation of various states.
Installation
MIXING
• WEAR IMPERVIOUS GLOVES,
such as nitrile when handling
product.
• FastSet
™
Concrete Mix can be
mixed in a barrel-type concrete
mixer or a mortar mixer
• Allow about 1 cu ft (28 L) of mixer
capacity for each 60 lb (27.2 kg)
bag to be mixed at one time
• Add approximately 2.25 quarts
(2.3 L) of fresh water to the mixer
for each bag to be mixed
• Turn on the mixer and begin
adding the dry concrete
• If additional water is needed
to achieve a slump of 3-4” (76-
102mm), add small amounts at a
time while continuing to mix. Do
not exceed this recommended
slump.
Divisions 3 & 32
03 01 00 Maintenance of Concrete
03 31 00 Structural Concrete