Owner manual

High Lifter Products, Inc.
Yamaha Mount and Headlight
Wiring Diagram
High Beam
Factory Light Wiring
Low Beam (Yamaha Factory Light Wiring)
Ground (Yamaha Factory Light Wiring)
Quick Connector
*Supplied with kit
*Insert onto li
g
ht bulb
To Factory Lights
Quick Splice Connectors
*Su
pp
lied with kit
Black= Ground On Wiring
Su
pp
lied With Kit.
Red= High Beam On
Wirin
g
Su
pp
lied With Kit.
White= Low Beam On
Wiring Supplied With Kit.
1. Expose factory wiring by cutting about a 3” slit in the wire sheathing that comes from the factory headlights
under the front fenders. Be careful not to cut into the wiring.
2. Using quick connectors supplied start splicing the wiring into the factory wiring.
3. Splice Red wire supplied to high beam.
4. Splice White wire supplied to low beam.
5. Splice Black wire supplied to ground.
6. Test the light to make sure connections are secure and everything is working correctly.
7. Finish the job by taping the connections and sheathing back up.
8. That’s it!