User Manual

High-Flying
HF-LPT200 Low Power WiFi Module User Manual
Shanghai High-Flying Electronics Technology Co., Ltd(www.hi-flying.com) - 51 -
+ok<CR><LF><CR><LF>
 Parameters:
 num：time calibration inverval，range:0~720, default:30 minutes, 10 minutes for
each step, set 0 means no time calibration automatically.
4.2.2.61. AT+NTPEN
 Function: Enable/Disable time calibration function. Setting is valid after reset.
 Format:
 Query Operation
AT+NTPEN<CR>
+ok=<status><CR><LF><CR><LF>
 Set Operation
AT+NTPEN=<status><CR>
+ok<CR><LF><CR><LF>
 Parameters:
 status：status of time calibration
 on：Enable time calibration
 off：Disable time calibration
4.2.2.62. AT+NTPTM
 Function: Query network time
 Format:
 Query Operation
AT+NTPTM<CR>
+ok=<time><CR><LF><CR><LF>
 Parameters:
 time：networ time, for example: 2013-10-9 16:10:42 Wed，if it shows Not
Available means that the time calibration function is not enabled or the module
doesn’t connect to the internet.
4.2.2.63. AT+WRMID
 Function: Set module ID;
 Format:
 Set Operation
AT+WRMID=<wrmid> <CR><LF><CR><LF>
 Parameters:
 wrmid: set module’s ID (within 20 characters).
4.2.2.64. AT+RLDEN
 Function: Set/Query nReload Pin function status
 Format:
 Query Operation
AT+RLDEN<CR>
+ok=<status><CR><LF><CR><LF>
 Set Operation