DL.2 Digital Light User Manual

CHAPTER 14
Fixture Motion Functions
DL.2 Digital Light User Manual 181
Projector Control
Control Parameter Projector Options
These Control parameter options remotely access and operate the internal projector’s menu
system
DMX
Value
Range
Control Option Description
180-184 Displays the Projector’s internal Menu System
185-188 Projector Up arrow
Note: These options control the directional
buttons on the projector menu display
and cannot be activated until you set the
Dimmer parameter to 0.
189-192 Projector Down arrow
193-196 Projector Left arrow
197-200 Projector Right arrow
201-204 Store Menu selection
The following options are always active and do not require the dimmer to be at zero
205-208
Projector Floor Orientation These commands activate the projector’s setting for specific
mounting or projection alternatives.
Once set, these commands maintain their value until reset even
after shutdown and re-homing. For example, if the Control
parameter is set to switch the unit to Ceiling orientation, then the
unit will remain in Ceiling orientation until another command is
sent to switch back to Floor. This allows the Control parameter to
revert to another value without losing the orientation or mirroring
status.
209-212
Projector Ceiling Orientation
213-216
Projector Front Projection
217-220
Projector Rear Projection
221-224
Input from External RGBHV
to Projector
Video input can be utilized with either RGBHV or VGA but not
both. You can select between RGBHV and VGA in the menu
system, (see
DMX_Control Screen on page 27). RGBHV is the
factory default.
Before using DMX to change DL.2 inputs, you must enable the
Projector Input by DMX option in the menu system (see
Set_Projector Screen on page 31) or through the CMA (see
Viewing Fixture Configuration Values on page 205).Once
the selection is made, allow about 10 seconds for the change to
take effect.
225-228 Graphics Engine to Projector
229-232
Input from S-Video In
(camera to Camera Out) to
Graphics Engine
233-236
Input from Camera to
Graphics Engine (default)
CAUTION:
Do not physically connect both the VGA and the RGBHV connectors at the
same time. Doing so can damage the projector and void the warranty.
.