Instructions / Assembly

[e-mail]
2
1-800-348-5004
FEATURES
PREPARATION
ASSEMBLING THE DETECTOR
With your Metal Detector, you can hunt for coins, relics, jewelry, gold, and silver just
about anywhere. This metal detector is versatile and easy to use.
Two Operation Modes: ALL METAL, DISC
ALL METAL - lets you search for all kinds of metal with auto ground balance and high
sensitivity. It’s the best operation mode.
DISC - discriminates what kind of metal being detected.
Volume - to adjust the volume level of speaker and headphone
Earphone Jack - lets you connect stereo earphones (not supplied) to the detector
in private.
View meter and Pointer - The meter pointer swings to the right if metal is found.
Water proof Search Coil - lets you search for metal objects under shallow water.
Note: The search coil is waterproof, but the control housing is not waterproof.
Adjustable Stem - lets you adjust the detector’s length for comfortable use.
Note: Your metal detector requires two 9V alkaline batteries (not supplied).
Assembling the detector is easy and requires no special tools. Just follow these steps.
1. Unscrew the knobs on the search coil and remove the knobs and the connector.
Insert the smaller stem and align the holes on the search coil bracket and the stem.
Push the connector through the holes, then replace and tighten the knobs.
2. Slightly loosen the lock nut on the bigger stem.
Insert the smaller stem into the bigger one
and tighten the lock nut.
3. Insert the latch on the top of the handle into
the assembly hole on the bottom of the control
box. Then slightly push the control box in the
direction of IN on the handle to fix the latch
in place.
4. Tighten the fixing screw properly.
Lock NUT
Bigger Stem
Smaller Stem
Fixing Screw
Latch
Control Box
Assembly Hole
The detector’s features include: