Manual

023-00354-Rev1.6 evc/epc User Manual 27
Copyright © High Country Tek, Inc.  2013
evc/epc Controller
With SAE J1939 Interface
SAE J1939
Set Point A or B % and Set Point RPM
 A SAE J1939 message can set the demand for coil A and B.
Measured RPM
The evc/epc controller can accept an SAE J1939 message containing the measured engine RPM on PGN: 0xF004
(61444) Source Address (SA): 0x00.
Timeout
 The box is red when the SAE J1939 message has timed out indicating a bus, connection or data error.
 Outputs for coil A and B will ramp to the default settings according to the “Command & Error” page.
 If “Recover from loss of signal" is “ON”, the outputs will resume normal operation when a valid SAE J1939
message is received. The box becomes green.
MAC ID  Displays and allows changing the MAC ID. It is the network address for this specific evc/epc.
Report Analog Values  ON
force to change the settings.