Manual
023-00354-Rev1.6 evc/epc User Manual 10
Copyright © High Country Tek, Inc. 2013
evc/epc Controller
With SAE J1939 Interface
The evc/epc can be powered by a +5V USB to allow configuration without connecting to a 12/24VDC system. A
message Supply Voltage is Lowappears on the screen. The user may communicate, change, and save
settings to the unit without driving the coil(s).
At start up the GUI searches the PC communication ports for the evc/epc controller.
The MAC ID determines nd and Status PGN addresses on the SAE J1939 bus. The user may
command multiple evc/epc modules on a single SAE J1939 bus. Please see SAE J1939 section.
The default MAC ID is 1.
or enter the will locate the controller. It will restart the operation with the
information and Mac .