User Manual

ENGLISH

ELECTRICAL INTERCONNECTION

GND

Connect the GND terminal with a suitable contact ground point on the vehicle’s chassis. The ground

wire must be as short as possible and must be connected to a blank metallic point at the vehicle’s

chassis. Ensure that this ground point has a stable and safe electric connection to the negative

“–”pole of the battery. Check this ground wire from the battery to the ground point if possible and en-

force it if required. Use a ground wire with a sufcient cross section (refer to the table and the recom-

mendations on the next page) and the same size like the +12V power supply wire.

REM

Connect a turn-on signal or the turn-on remote signal of your head unit (REM) with the REM terminal

of the amplier. Use therefor a suitable cable with a sufcient cross section (0,5 mm

). Hereby the

amplier turns on or off with your head unit. If you use the AUTO TURN-ON function (refer to page 20,

section 13), the REM terminal does not need to be connected.

+12V

Connect the +12V terminal with the +12V pole of the vehicle’s battery. Use a suitable cable with a suf-

cient cross section (refer to the table on the next page).

BEFORE CONNECTING

For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure

a sufcient prole section (refer to the table on the next page) and a suitable fuse rating and the conductivity

of the cables when you purchase your wiring kit. Clean and remove rust-streaked and oxidized areas on the

contact points of the battery and the ground connection. Make sure that all screws are xed tight after the instal-

lation, because loose connections cause malfunctions, insufcient power supply or interferences.

1 3 4

< 30 cm >

VEHICLE

BATTERY

min. 30 A