Manual

20
ENGLISH
ELECTRICAL INTERCONNECTION
GND
Connect the GND terminal with a suitable contact ground point on the vehicle’s chassis. The ground
wire must be as short as possible and must be connected to a blank metallic point at the vehicle’s
chassis. Ensure that this ground point has a stable and safe electric connection to the negative
“–”pole of the battery. Check this ground wire from the battery to the ground point if possible and
enforce it if required. Use a ground wire with a sufcient cross section (refer to the table on the next
page) and the same size like the +12V power supply wire.
REM
Connect a turn-on signal or the turn-on remote signal of your head unit (REM) with the REM terminal
of the amplier. Use therefor a suitable cable with a sufcient cross section (0,5 mm
2
). Hereby the
amplier turns on or off with your head unit.
NOTE: If you operate the amplier via HI LEVEL INPUT, the REM connection does not have to be
used.
+12V
Connect the +12V terminal with the +12V pole of the vehicle’s battery. Use a suitable cable with a suf-
cient cross section (refer to the table on the next page).
BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufcient prole section (refer to the table on the next page) and a suitable fuse rating and the conductivity
of the cables when you purchase your wiring kit. Clean and remove rust-streaked and oxidized areas on the
contact points of the battery and the ground connection. Make sure that all screws are xed tight after the instal-
lation, because loose connections cause malfunctions, insufcient power supply or interferences.
1
2
3
1 3
4
5
< 30 cm >
VEHICLE
BATTERY
min. 80 A
2
< 30 cm >
80 A