User Guide

Adjust input and output level
controls with test tone
After all connections have been made to unit and powered on and
working turn volume of source unit up to 3/4.
Disconnect output RCA’s (1 and 3). Reference Pg. 4&5
Adjust input level range switch (8) to the appropriate setting based on
input (RCA lower position, speaker level in upper position).
Reference Pg. 4&5
Play test tone provided.
Turn input level control clockwise until Clip Indicator LED (above)
illuminates and then turn down(counterclockwise) until LED turns off.
Do same as above for the Output Level control Turn input level control
clockwise until Clip Indicator LED (above) illuminates and then turn
down(counterclockwise) until LED turns off.
Once E and F have been done you can stop the test tone track and re
connect your RCA outputs (1 and 3). Reference Pg. 4&5
While playing music you can then adjust and ne tune the Bass level (4)
Width and Sweep (5). Reference Pg. 4&5
Sweep Control
Allows you to select the center
frequency the BXiPRO3.0 outputs
Width Control
Controls how wide the frequency range
that is centered on the sweep frequency
There are two test tones 1kHz for high level and 100Hz for low level
F
G
H
A
D
B
C
E
Frequency response Full Range
Width
-6
+26
-4
-2
0
+2
+4
+6
+8
+10
+12
+14
+16
+18
+20
+24
10 10020
30
40 50 60 70 80
90
Hz
Narrow
Wide
Frequency response Full Range
-6
-4
-2
0
+2
+4
+6
+8
+10
+12
+14
+16
+18
+20
20
20040 60 80 100
100Hz50Hz
120 140 160 180
Hz
Sweep