Operator’s Guide BXiPRO3.
Thank you for purchasing the HIFONICS BXiPRO3.0 Digital Bass Enhancement Processor. This unit has the ability to fine tuning bass width and sweep for increased sound performance. Please read the entire manual to ensure proper connections and application. CAUTION Always consider consulting a professional audio installer before installing any audio components. Be careful and take your time. Do not let wires make contact with metal edges or hot engine components.
Mounting and Hardware Prior to mounting, connect the wires to ensure proper operation. MOUNTING 1. Select the desired mounting location that allows the unit to be mounted on a flat surface with room for connections. 2. Use the mounting brackets that are attached to the unit and use the provided hardware for mounting the unit. Make sure there is proper clearance for the mounting bracket screws when attaching to selected location.
Functions & Operations 1 Adjustable bass enhancement preamp output 2 Bass remote input 3 Preamp full range output 4 Adjustable bass level output 5 Adjustable bass width and sweep adjustments 6 Output level control with clip indicators 7 Input level control with clip indicators 8 Selectable input level range (RCA or speaker level) 9 Selectable turn on trigger (remote wire input, DC sense and signal sense) 10 Low level inputs (RCA level) 11 High level input (speaker level) 12 Power connector with two rem
Functions & Operations 5 Output Clip Indicator 4 6 Input Clip Indicator 7 8 9 13 A B
Adjust input and output level controls with test tone There are two test tones 1kHz for high level and 100Hz for low level A After all connections have been made to unit and powered on and working turn volume of source unit up to 3/4. B Disconnect output RCA’s (1 and 3). Reference Pg. 4&5 C Adjust input level range switch (8) to the appropriate setting based on input (RCA lower position, speaker level in upper position). Reference Pg. 4&5 D Play test tone provided.
Unit Setup with Aftermarket Source Unit
Unit Setup with Factory Source Unit
Diagnostics & Trouble Shooting The key to finding the problem in a troubled sound system is to isolate parts of that system in a logical fashion to track down the fault and correct the issue. The diagnostic system will not shut down the crossover or the amplifier(s), although the amplifier(s) own protection circuitry may shut the amplifier(s) down, should a fault status occur. You will need to consult the owners manual for that particular amplifier.
Specifications Size 109W x 134L x 30.5H Fuse value 1A mini ATC Voltage range 9.5V -15V Bass remote type HF-U-02 Fixed voltage output full range 4V Adjustible subwoofer output voltage 0V -9V Maximally Flat Frequency Response Main (-3dB) 10Hz to >50kHz Input Impedance Low level inputs 20k Ohms Input Impedance High level inputs 20k Ohms Maximum high level Input Voltage on any input before clipping >48V Maximum Output voltage at 1.0% THD+N (subwoofer output) 9.
