Owner's Manual
26
USER INTERFACE OF THE SOFTWARE
Here you can make countless settings and adapt them to your sound system, which can be heard immediately in real time via the DSP
device. As soon as you are nished conguring a setting, it can be transferred to one memory locations in the DSP device. You can store
up to 10 different settings and select the remote control at any time during operation. The following section explains the various functions
of the M-CONTROL 2 user interface.
Channel Setting“: Opens a dialog box where you can select the congurations for your desired
sound system.
There you can freely dene the assignment of the inputs (INPUT) and outputs (OUTPUT) per
channel on the DSP device.
In „SPEAKER TYPE“, you can select the desired speaker for each channel. This means that
the appropriate parameters are already preset at the respective channel, and you only have to
perform the ne adjustment.
„MIX“ must be selected when using the high level inputs on the DSP device. The audio signal
is summed.
Under „2CH“, „4CH“ or „6CH“ (input assignment), you can select an already preset sound
system variant, which you can set beforehand. All you have to do is make the ne adjustment.
2
1
3
4
5
6
Open: Opens a previously saved setting on the PC.
LINK TO DEVICE: Connects the PC via USB to the DSP device.
Save: Saves a setting in a le on the PC with the current lename used. If no le name has been selected before, you can
specify any lename in the following dialog.
SaveAs: Saves the setting under a different lename, which you can specify in the following dialog.
Factory Setting: Resets all settings to the factory default.
2 17
16
14
15
8
10
11
13
12
9
7
1
3 4 5 6
FUNCTIONAL INSTRUCTIONS