RoHS USER MANUAL WIRELESS CARPLAY ADAPTER
Customer Service: Thank you for your purchase and your support. If you have any issues with your order, please contact our customer department at the following email address: support-us@hieha.net Do not hesitate to get in touch with us if you meet any difficulties installing the unit. We are always available to answer any of your questions and more than happy to take your suggestions.
Installation Steps: 1. Please connect the wireless CarPlay adapter to your car unit USB port. 2. Turn on the Bluetooth and Wifi function. 3 Pair SmartBox-XXXX device , allow contacts and and sync 4. Press " Use CarPlay" and activate CarPlay. Tips: 1. Make sure that the wireless CarPlay adapter is connected to the USB or Type-C interface of the original car screen with the iPhone interconnection function. 2.
Support Upgrade Online: 1. Please connect the wireless CarPlay adapter to a USB power adapter. 2.Turn on your iPhone's WiFi and join the WiFi devices named "smartBox_xxxx". 3. Enter the password '88888888' and find the IP address 192.168.1.101 in your Safari. 4. After accessing the IP page, you can download the firmware online from your iPhone,which needs to connect to the "smartBox-xxxxx" network until the upgrade is completed.
Warm Tips: * Generally, it takes 3-4 minutes to upgrade new firmware, and the orange/green light will keep flashing until the upgrade is successful. * Do not power off during the upgrade process. * If the wireless CarPlay adapter works normally, please DO NOT UPGRADE. Attention: 1.Before connecting, please make sure that the Bluetooth and WiFi of the mobile phone are not connected to other devices. If there is a connection, please disconnect the Bluetooth and WiFi of other devices on the mobile phone.
3.After the CarPlay connection is successful, the Bluetooth of the mobile phone will be disconnected from our device. At this time, if the Bluetooth of the mobile phone is connected to other audio devices, the sound will Not come from the original car speaker. 4.The wireless carplay function may not be enabled when the car is started again. At this time, you can re-establish the connection by plugging and unplugging the box. 5.This product does not support all original cars with wired CarPlay function. 6.
9.To turn off the CarPlay, you need to disconnect the Bluetooth and WiFi of the device on the mobile phone， Or unplug the box. 10.If the wireless CarPlay function is used under normal or special environment, and the other party cannot hear clearly or has an echo when receiving and receiving calls, please turn on the Bluetooth hands free calling of the mobile phone.
of the original car and vehicle system,or improper upgrade of this product,it may cause the experience of this product. Decline or loss of function (partially or completely). Device disconnection exemption: This product may cause the disconnection phenomenon during the use, such as the connection time is too long or the disconnection problem of the original car's wired CarPlay itself.This phenomenon is affected by external conditions or the environment. The product has been optimized.
U.S Compliance: Output power listed is conducted power. This device contains 20,40 and 80 MHz signal bandwidth. the antenna used with this transmitter must be installed to provide a minimum separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. except in accordance with FCC multi-transmitter product procedures. End-users must be provided with operating procedures for satisfying RF exposure compliance.
RoHs Compliance: AUFN Inc. Hereby declare that this product is fulfills the requirement of the Directive 2011/65/EU (RoHS) and amendment Commission Delegated Directive (EU) 2015/863 with effective from 22 July 2019. The third-party certification and testing agency entrusted by the company is Anbotek. And a copy of the test report has been stored in the Annotek database.
