User's Manual

4
BATTERY INSTALLATION
REMOTE SENSOR
NOTE: Install the batteries; select the channel and temperature in °C or °F before mounting the remote
sensor.
• Remove the screws from the battery compartment with a small screwdriver.
• Set the channel. The switch is located in the battery compartment. Channel 1 is typically selected if only
one remote sensor is being used.
• Install 2 “AAA” size alkaline batteries (not included) matching the polarities shown in the battery
compartment.
• Replace the battery compartment door and secure the screws.
• Secure the remote sensor in the desired location.
SPECIFICATIONS
Remote Sensor
Remote Temperature
Proposed operating range with alkaline batteries:
-20°C to + 70°C (-4°F to + 158°F)
Temperature resolution: 0.1°C/0.2°F
RF Transmission Frequency: 433 MHz
RF range: 30 meters
Temperature & humidity transmission cycle: approximately 45 seconds
Low battery indicator
Wall-mount of Table stand
Power
Remote Sensor: 2 AAA size 1.5V batteries (not included)
Dimensions
Remote sensor: 2.35(L) x 3.77(H) x 0.86(D) inches