Spec Sheet

Application
HID’s ProxPro
®
II proximity reader for access control combines performance, reliability,
and ease of installation into a two-piece, weatherproof potted enclosure. International
users will appreciate the multilingual installation manual, lower voltage requirement and
flexible mounting options.
Features
w Two-piece reader design allows for easy installation.
w Available with a Wiegand or Clock-and-Data interface.
w Provides high reliability, consistent read range and low power consumption.
w Features include multicolor LED and internal or host control of the LED and beeper.
w Mounts directly on metal with minimal impact on the read range performance.
Optional kit enables mounting behind glass.
ACCESS reliability.
New Generation Proximity Card Reader • 5455 (Wiegand), 5458 (Clock-and-Data)
125 kHz Proximity
ProxPro
®
II Reader
Feature ProxPro ProxPro II
Supply Voltages 12V and 24V 5V and 12V
Voltage Range min/max 10 / 28.5VDC 5 / 16VDC
Current Draw avg/peak 100 / 120 mA 25 / 125 mA
Read Range at 12VDC
(Proxcard
®
II/ISOProx
®
II)
8" (20 cm) / 7" (17 cm) 9" (22 cm) / 8" (20cm)
IP Rating IP55 IP55
European/Asian mounting holes No Yes (vertical)
Weatherproofing method Rubber O ring
Fully potted electronics
Cover installation method
4 screws, then
snap in bezel
Snap on cover
Custom molded logo
Screw Terminals
Available (one-time
tooling charge)
Termination method
No
Wire Pigtail
Metal compensation Jumper
No, but provides equivalent
performance on metal
LED/Beeper configuration
DIP Switch or
Command Card
Command Card
Custom Firmware
Socketed Processor,
change part
Order from factory
Serial Version available Yes No
Keypad Version available Yes No
Wiegand Pullup Select 5 or 12V DIP Switch No
Tamper Switch Yes
No, but electronics are
potted to prevent tampering
Multilingual installation manual No Yes
Glass mounting kit (optional) Yes Yes
Compare features
of the ProxPro II to
the original ProxPro
reader (still available):