User's Manual

Table Of Contents

Safety Messages (review carefully)

Symbol

Critical Instructions for Safety purposes

Danger:

Failure to follow these installation guidelines can result in death

or serious injury.

Information that raises potential safety issues is indicated by a

warning symbol (as shown to the left).

• To prevent personal injury, refer to the following safety

messages before performing an operation preceded by this

symbol.

• To prevent personal injury, always remove the power cord prior

to performing repair procedures, unless otherwise specified.

• To prevent personal injury, make sure only qualified personnel

perform these procedures.

Caution:

This device is electrostatically sensitive. It may be damaged if

exposed to static electricity discharges.

Information that raises potential electrostatic safety issues is indicated

by a warning symbol (as shown to the left).

• To prevent equipment or media damage, refer to the following

safety messages before performing an operation preceded by this

symbol.

• To prevent equipment or media damage, observe all

established Electrostatic Discharge (ESD) procedures while

handling cables in or near the Circuit Board and Printhead

Assemblies.

• To prevent equipment or media damage, always wear an

appropriate personal grounding device (e.g., a high quality wrist

strap grounded to avoid potential damage).

• To prevent equipment or media damage, always remove the

Ribbon and Cards from the Printer before making any repairs,

unless otherwise specified.

• To prevent equipment or media damage, take jewelry off of

fingers and hands, as well as thoroughly clean hands to remove

oil and debris before working on the Printer.

DTC4500 Card Printer/Encoder User Guide