User's Manual

Table Of Contents

Selecting the Advanced Settings tab

Setting Option

Flipper Lam Height

Offset

This is a calibration driven value and should not be

adjusted. If the Flipper unit is replaced and has not been

calibrated this value may need to be adjusted.

(Note: This is factory set and should not be changed

unless directed by a technician.)

Mag HI-Co Voltage Offset

This option changes the voltage going the magnetic head.

(Note: This is factory set and should not be changed

unless directed by a technician.)

Mag Lo-Co Voltage

Offset

This option changes the voltage going the magnetic head.

(Note: This is factory set and should not be changed

unless directed by a technician.)

OLED Contrast

(display contrast)

Use this option to increase or decrease the contrast of the

printer OLED (if applicable).

Resin Heat Adjust

Use this adjustment for Black resin text and barcodes

appear faded or too light/dark.

Adjust the Resin Heat, Front (K) or the Resin Head, Back

(K) as needed.

• Move the slider to the left to cause less heat to be

used in the printing process, causing resin images to

be lighter or less saturated.

• Move the slider to the right to (a) cause more heat to

be used or (b) cause the resin image to be darker or

more saturated.

(Note: This control can be helpful for fine-tuning the

transfer of resin text and bar codes.)

DTC4500 Card Printer/Encoder User Guide