User's Manual

Page 16 of 19 February 13, 2008
© 2008 HID Global Corporation. All rights reserved.
SmartID Proximity Reader - 8030-901, Rev A.0
5.5 Mullion Reader Mounting Plate – Spacer
The sizes in the drawing are in millimeters, 1 mm is 0.039 in.
Figure 5 Mounting Plate Spacer
February 13, 2008
© 2008 HID Global Corporation. All rights res
e
SmartID Proximity Reader - 8030-901, Rev A.0
2 Overview
The SmartID 13.56MHz and SmartTRANS 13.56MHz + 12
slim door mountable design to match any installation envir
o
LED’s and buzzer allow the SmartID Readers to be mount
e
The SmartID reader accepts 5 to 24 Volts DC. The reader
o
Wiegand, Clock-and-Data (Magstripe ABA / ISO7811), RS
2
hardware interfaces.. The 5 Volt DC capabilities allow the r
e
reader systems without rewiring or pulling new cables. The
high reliability, consistent read characteristics and low pow
e
The SmartID reader family includes RS232/RS422/RS485
read-only and read/write operations.
Standard capabilities include host system controlled red an
buzzer.
2.1 Mullion Mounting
Ideally suited for mullion-mounted door installations or any
f
not cover junction box). An optional single-gang electrical
b
available.
2.2 Indications
When a card is read successfully, the card data is sent to t
h
buzzer sounds a short 3KHz beep. Both LED’s and the bu
z
by the host system.
2.3 Connections
The SmartID reader family has a flexible and reliable conn
e
space for the cable and the connector within the SmartID h
o
with silicone to withstand harsh environmental conditions.
2.4 Output Protocols
The SmartID reader family operates with any facility, syste
m
scheme. The data output format, contents and length are d
personalization of the card or configuration of the reader.
The readers are intended for connection to an Access Con
t
compatibility to the reader is referenced in the control unit’s
2.5 Security
The SmartID reader family offers high security challenge r
e
protect the RFID air interface against various attack schem
e
playback attacks.