User's Manual

Installation Guide OMNIKEY
®
Smart Card Reader
© 2010 – 2011 HID Global Corporation - All rights reserved. 3
Specifications and Installation
Note: Radio module 5127 should not be installed within a system
and operated simultaneously with other radio transmitters. When
integrating the 5127 module into a final product, the product needs
to have a label showing:
Contains FCC ID: JQ6-OK5127FARGO, IC: 2236B-OK5127FARGO
For further information, contact HID support: http://support.hidglobal.com/.
For driver setup, consult the OMNIKEY Smart Card User Guide
(http://www.hidglobal.com/documents/ok3121_userguide_ins_en.pdf).
CAUTION: Install the drivers prior to attaching the OMNIKEY reader with the computer.
USB Connected Reader Specifications
Operating Temperature
0°-55°C / 32°-131°F
PC Connector Cable
180 cm / 70.9 in
(150 cm / 59,1 in - Models 1021 & 3021)
Meantime between Failure (MTBF)
500,000 Hours
Host Interface
USB 2.0 CCID (USB 1.1 Compatible)
Host Data Transmission Speed
12 Mbps (USB 2.0 Full Speed)
Power Supply
Bus Powered
USB Connected Reader Installation
1. Connect the reader with your computer; plug the USB connector into your
computers USB port.
2. When the reader is operational, the LED illuminates.
3. For contactless operation, hold the card next to the reader logo. For contact
smart cards, insert the card into the reader with contacts facing up.
4. When the reader is exchanging data with a card (reading/writing), the LED blinks.
PCMCIA and ExpressCard Reader Specifications
4321
4040
Operating Temperature
0°-55°C / 32°-131°F
Meantime between Failure (MTBF)
500,000 Hours
Host Interface
ExpressCard™ 54 mm
PCMCIA
Host Data Transmission Speed
12 Mbps
16 Mbps
Power Supply
Bus Powered
PCMCIA