FlexPass OFR100 OPERATING AND INSTALLATION MANUAL FlexPass OFR100 Open Format Reader K02000-000 -1- 06/29/01
FlexPass OFR100 Table of Contents K02000-000 1. Important Safety Instructions 3 2. Product Description 3 3. Features 4 4. Identifying Supplied Parts 4 5. Specification 4 6. Installation 5 7. Wire Color Coded & Wiring 6 8. Wire Connection to A Host/Controller 6 9. Wire Connection to SDC1000 7 10. Operation 7 11. FCC Registration Information 8 12.
FlexPass OFR100 1. Important Safety Instructions When using your FlexPass OFR100, basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons. In addition, the following should also be followed: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. If necessary, use mild soap. 4.
FlexPass OFR100 3.
FlexPass OFR100 6. Installation 6-1. Mullion/Wall Mount Drill two 6-32 or M3 holes 3.3"(8.38cm) apart in vertical and drill one 1/2" hole for the reader cable 1.7"(4.31cm) apart from the top hole. (If you have installed an electric gang box then skip this step and go to step 6.2.) 6-2. Put reader cable into the center hole and install the reader module by using two 6-32 or M3 screws (Not included). 6-3. Put bezel on to the reader module then push bezel until you hear the locking sound. 6-4.
FlexPass OFR100 7. Wire Color Coded & Wiring I/O Port Name POWER Power (DC +5V ~ +12V) Power (Ground) Signal Name Color Coded VDC(+) VDC(-)(GND) Red wire Black wire INPUT Beeper control LED control Beeper LED Blue wire Brown wire OUTPUT(Wiegand Format) Wiegand Data-0 Data-0 Wiegand Data-1 Data-1 Green wire White wire OUTPUT(ABA Track II Format) ABA(Card Present) CP ABA(Clock) CLK ABA(Data) Data Orange wire White wire Green wire 8.
FlexPass OFR100 9. Wire Connection to FlexPass SDC1000 Single Door Controller 10. Operation 10-1. Once power is applied, the Red LED should be on and you should hear three beeping sounds indicating that the reader is in standby mode after a successful initialization and diagnostics. 10-2. Present proximity card to the reader until you hear the beeping sound and see the LED changes color to Green.
FlexPass OFR100 11. FCC REGISTRATION INFORMATION FCC REQUIREMENTS PART 15 Caution: Any changes or modifications in construction of this device which are not expressly approved by the manufacturer for compliance could void the user's authority to operate the equipment. NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interface, and 2.
