User's Guide

3.14 First Fill
When a system is used for the first time, the printer will go through a sequence to load ink into the
machine. During this process, if an ink level fault or other error occurs, reboot the printer by turning the
power switch off for 5 seconds and then on again, and the system should resume with the initial ink fill.
The initial fill is complete when the “Ready” screen appears on the system display.
3.15 Ethernet Connection
To connect the HID ELEMENT system to the user system, plug an ethernet cable connected to the user
network into the ethernet port on the back of the HID ELEMENT input module, located above the unit
power switch, circled in the image below in red.