User's Manual

identiCLASS Developer Tool Kit User Guide
Regulatory
HID OEM Reader Modules
The following describes HID OEM Reader modules regulatory guidelines.
 UL Recognition (Recognized Component) to UL294 for the USA and CSA C22.2 No.
205 for Canada. The mark is cRUus where the “R” is backwards and “Security” appears
above the circle containing the Mark.
 OEM Final Product UL Listing
Because OEM Modules are cRUus recognized, UL will treat them as a recognized component
and only the remainder of the final product will need evaluation for a listing. The mark will be
cULus with “Security” written above the circle containing the mark.
OEM Final Product Radio Certifications
 Because HID OEM modules contain a radio transmitter operating at 13.56 MHz and the
module is integrated into the OEM’s final product, Radio Certification will be required for
the final product.
For 3300 Reader Core only:
 FCC Certification can be obtained by submitting the final product to a
Telecommunications Certified Body (TCB) laboratory that can perform the testing and
issue the FCC Grant. Standard: Part 15, Subpart C.
 Often the same TCB can also test to Canada requirements and grant certification as a
Certification Body (CB). Standard: RSS-210, RSS-GEN and RSS-310 where
applicable
 The same laboratory may also be an EU Communications Assessment Body (CAB) that
is accredited to test to R&TTE Directive requirements for CE Marking. Standards: EN
300 330, EN 301 489-3, EN 50130-4, and IEC60950
 A laboratory that is a CAB testing to R&TTE Directive requirements will also be testing
to Australia and New Zealand requirements because of a common test standard.
Standard: AS/NZS 4268
 Asian country certifications are obtained on an individual country basis.
OEM Final Product US Dept. of Commerce Bureau of Industry and Security (BIS) approval
is required for USA based companies who export and re-export products using encryption.
Regulatory Compliance Assistance - HID Global will provide technical assistance and laboratory
recommendations as required.
FCC / Canada Radio Certification
These devices comply with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Le fonctionnement est soumis aux deux conditions suivantes : (1) Ce dispositif ne peut pas causer de
perturbations nuisibles et (2) ce dispositif doit accepter toute perturbation quelconque qu’il reçoit, y
compris des perturbations susceptibles de provoquer un fonctionnement indésirable. Les changements
ou modifications n’ayant pas été expressément approuvés par la partie responsable de la conformité
peuvent faire perdre à l’utilisateur l’autorisation de faire fonctionner le matériel.
October 2010 Page 23 of 24
HID GLOBAL CONFIDENTIAL AND PROPRIETARY INFORMATION. Use and disclosure of this information is strictly
restricted by the terms of a non-disclosure agreement with HID Global Corporation. If you have received this information and
are not an intended recipient or are not subject to or do not agree to be bound by the terms of the non-disclosure agreement,
please immediately return this document to HID Global Corporation, 15370 Barranca Pkwy, Irvine, CA 92618-3106..