User's Manual
Table Of Contents
iCLASS SE
INSTALLATION GUIDE
4
PLT-01545, A.0
U90 (U90.915 & U90.865)
© 2014 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
ATTENTION
Observe precautions for handling
ELECTROSTATIC SENSITIVE DEVICES
Wiring
2
* Tamper Output - When activated, output synchronizes to ground (default).
** Dependent upon reader conguration. See the HTOG for Wiegand and Clock-in-Data congurations.
Terminal Description Terminal Description Terminal Description
P1-1 Beeper Input (BEEP) P2-1 GPIO4 (RS485-Y / TXA) P3-1 Earth Ground
P1-2 LED Input (GRN) P2-2 GPIO3 (RS485-Z / TXB) P3-2 Normally Closed (NC) - Relay 1
P1-3 Ground (GND) P2-3 ** Wiegand Data 0 / Data (DATA0/DATA) P3-3 Common (COM) - Relay 1
P1-4 +VDC P2-4 ** Wiegand Data 1 / Clock (DATA1/CLK) P3-4 Normally Open (NO) - Relay 1
P1-5 Unused (DRAIN) P2-5 * Open Collector Output / Tamper (OC/TMPR) P3-5 Normally Closed (NC) - Relay 2
P1-6 LED Input (RED) P2-6 GPIO2 (RS232-R / RS485-RXB) P3-6 Common (COM) - Relay 2
P1-7 Hold Input (HOLD) P2-7 GPIO1 (RS232-T / RS485-RXA) P3-7 Normally Open (NO) - Relay 2
P3-8 Normally Closed (NC) - Relay 3
P3-9 Common (COM) - Relay 3
P3-10 Normally Open (NO) - Relay 3