User Manual
902 ~ 928 MHz Wireless-LAN
WS200 / WM200 User Manual
2001-01-09
LQWHUQDOXVHRQO\
Mt l S t dSlti K
<Figure 3-2, Mobile connection with Validator, Antenna and AC adapter>
3.1. Prepare the WS200 / WM200 wireless-LAN
The following sections describe how to connect the WS200 / WM200 wireless-
LAN to External Device and how to set up and operate the WS200 / WM200
wireless-LAN.
3.1.1. Those following equipment will be used to set up the system, but the system
operation should be verified by qualified personnel in MSSK and professionally
installed.
3.1.2. One Validator and One PC for BMS.
3.1.3. One WM200 Mobile.
3.1.4. One RS-232 cable (with power-line) for Mobile.
3.1.5. One Mobile (WM200)’s Antenna & Antenna Cable (200mm Dipole Antenna :
specified by MSSK).
3.1.6. One WS200 Station.
3.1.7. Four RS-232 cables (with no power-line) for Station. (Station use AC-Power
adapter.)
3.1.8. Four Station (WS200)’s Antenna Extension Cables
3.1.9. One Station (WS200)’s Antenna & Antenna Cable (800mm Whip Antenna :
specified by MSSK).
3.1.10. AC Power Adapter & Power Cable for Station.
3.2. Connecting WS200 / WM200 wireless-LAN
To connect both the wireless modems, please do the following procedures.
For Mobile,
A. One side of RS-232 cable connects the serial port of Validator , and the
other side connects with the rear of Mobile.
B. Mobile’s antenna & antenna cable connects with Mobile. (Please, do not use
other device might cause the rf-power variation.)
C. Place the antenna on window of BUS.
D. Validator power on, then the power indicator-LED on Mobile will turn on.
(+24V power deriving by Validator)
Exhibit 08