User Manual
902 ~ 928 MHz Wireless-LAN
WS200 / WM200 User Manual
2001-01-09
LQWHUQDOXVHRQO\
Mt l S t dSlti K
For Station,
A. One side of the RS-232 cable connects connector on the rear panel of
Station, and the other side connects with the serial port of PC (BMS).
B. Four-antenna extension cables connect on each point. (See Figure 2-5)
C. Station’s antenna & antenna cable connects with Station. (Please, do not use
other device might cause the rf-power variation.)
D. Place the antenna on higher position.
E. Plug the AC power adapter (AC to 24VDC) into power inlet of the Station and
power on.
F. Then power indicator-LED on the Station will turn on.
<Figure 3-3, One Validator connection with one BMS, via Mobile and Station.>
4. Applications
Wireless Networking
With appropriate operating(wireless application program), data of the WS200 / WM200
within a workgroup may be shared without physically connect them together.
Exhibit 08