User's Manual

K02008-001 REV. A

• The Shield wire is not terminated within the reader.

3.0 Operation

When power is first applied to the reader, it performs an internal circuit check. If it is functioning properly, the

reader will flash the Green LED, beep three times, enter ready mode, and display the Red LED.

3.1 Presenting the Card

To obtain maximum read range, present the card to the reader (keeping the card parallel to the reader),

and move it toward the face of the reader until the reader beeps and flashes. This indicates that the

card has been read and data has been transferred to the host.

Data Output

The Reader outputs in 26-bit Wiegand format only.

4.0 Specifications

Operating Voltage Range 8 VDC – 14 VDC

Absolute Maximum 14 VDC

Average Current VDC (maximum)

80 mA

Read and Report Speed (Wiegand) 500 mSec

Wiegand Data Pulse Widths

20µSec -- 100µSec (40.5µSec default)

Wiegand Data Interval

200µSec --10mSec (2mSec default)

Any Card Lockout Delay

500 mSec

5.0 Regulatory

FCC Compliance: This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

Canadian Compliance: Operation is subject to the following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference, including interference that may

cause undesired operation of the device.

UL: The reader is intended to be powered from a limited power source output of a previously certified

power supply.

CE Compliance: Hereby, Indala, declares that this proximity reader is in compliance with essential

requirements and other relevant provisions of Directive 1999/5/EC.