User's Manual

K02021-000 Rev A April 2006

3.5 Controls and Indications

3.5.1 Wiegand and Mag Stripe Single-Line Control LED Host to

Reader Interface Wiring

• There is no LED OFF state in this configuration.LED is red when the brown wire is high

(above 2.2 VDC or not connected).

• Pull brown wire low to change LED color to green.

• Toggle brown line high-low at a rate of 100 Hz to 1 kHz, 50% duty cycle, to produce amber

LED color.

• Pull blue beeper wire low to activate audio beep tone.

3.5.2 Wiegand Dual-Line Control LED Host to Reader Interface

Wiring

• The LED is OFF when both brown and orange wires are high (above 2.2 VDC or not con-

nected).

• Pull brown wire low to activate red LED.

• Pull orange wire low to activate green LED.

• Pull orange and brown wires low simultaneously to activate amber LED.

• Pull blue wire low to activate audio “beeper” tone.

3.5.3 Option Cards

3.5.3.1 Single-Line and Dual-Line LED Control

This option card toggles the state of the LED control lines (Indala part number 07260-001). If one beep is

heard when the card is presented, the reader is set to a single line LED control. If two beeps are heard, the

reader is set to a dual line LED control.

3.5.3.2 QuickFlash Beep Enable/Disable

This option card toggles the state of the QuickFlash beep option (Indala part number 07259- 001). If one

beep is heard when the card is presented to the reader, the automatic beep is enabled. If two beeps are

heard, the automatic QuickFlash beep is disabled.

3.5.3.3 QuickFlash LED Enable/Disable

This option card toggles the state of the QuickFlash LED option (Indala part number 07258- 001). If one

beep is heard when the card is presented to the reader, the automatic QuickFlash is enabled. If two beeps

are heard, the automatic QuickFlash LED is disabled.