User's Manual

 9/34#--#4+0/



  
 !
 '(02' -#5/%*+/) 4*' CADTools 120)2#. 4*'  .534 $'
107'2'& #/& %0//'%4'& 40 4*'  #3 3*07/ $'-07 #,' 4*'3'
%0//'%4+0/3 53+/) 4*' %#$-'3 #/& 107'2 3511-8 1206+&'& +/ 4*'
0&'-  #2#--'-  /34#--#4+0/ +4
9Do not attach or remove the ribbon cable from the
16Ćpin connector on the Control Board with DC power on (either
from the Terminal or from the DC Power Supply included with the
Installation kit). Doing so may result in corrupted Control Board
firmware.
ąMake sure that the PC's parallel port is set for
. This setting is usually provided in the PC's BIOS
setup menu (accessed by pressing a designated key during the
PC's bootup period).
 -+%, 0/ 4*' 4#24 $5440/ 4*'/ 3'-'%4
 ⇒  ⇒ 
Ċ continued on next page Ċ

!
"
 
 
 
 
 