User's Manual

FlexSmart™ 607X Series Installation Guide – 6075-900, B.2
Notes:
• Keypad outputs only available
• The system must have a single earth ground point.
• As shown, do not connect shield (screen) wire at reader cable splice.
• For open collector (non-terminated output), consult your system manufacturer for correct cable length
and type.
Regulatory
FCC
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
UL
This reader is intended to be used with UL294 Listed Control Equipment.
CE
Hereby, HID declares that this proximity reader is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
Models
Readers
6075 HID Format MIFARE Reader
6076 Custom MIFARE Reader
6077 Custom DESFire Reader
Keypad Readers
6071 HID Format MIFARE Reader
6072 Custom MIFARE Reader
6073 Custom DESFire Reader
February 5, 2007 Page 7 of 8
© 2007 HID Global Corporation. All rights reserved.