User Manual

11 Hardware Installation
AIR ID
Hardware Installation
Locate an open serial port on the system. If there is a 9 pin serial
port connector present, attach the Base Unit’s 9 pin connector to
the PC serial port. The pcProx Base Unit is powered by either the
keyboard or mouse port using the small round in-line connector.
Plug this connector into the PC’s keyboard or mouse port, and
then plug the corresponding keyboard or mouse cable into this
adapter.
You may place the Base Unit next to your monitor, beside your
PC, or where you feel it is appropriate.
Windows 95/98 Users
To verify which serial port is available, follow these steps:
1. Click Start
2. Select Settings
3. Click Control panel
4. Select System
5. Select Device Manager
6. Listed under the category, Ports, locate an available serial
port (i.e. COM1 or COM2). Verify this port agrees with the
connector attached to the Base Unit.
Windows NT Users
To verify which serial port is available, follow these steps:
1. Click Start
2. Select Settings
3. Click Control panel
4. Select Ports
5. Listed under the category, Ports, locate an available port( i.e.
COM1 or COM2)
6. Verify this port agrees with the connector attached to the Base
Unit.