Install Manual

_____________________________________________________________________________________________________
HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL [phone] [phone] FAX [phone]
Web page, E-mail - www.hidcorp.com - IQ Card Reader Installation Manual 6055-910 Rev A Page
3
of
5
PARTS LIST (Included)
Quantity
- IQ Card Reader with snap-on cover and 18” cable
1
- #6-32 x 1” self-tapping panhead screw
2
- Installation manual
1
PARTS LIST (Not-Included)
Quantity
- Wire splice
9
- DC Power supply 12 VDC
1
1 Mounting Instructions
• Determine an appropriate mounting location. The
reader may be mounted to any surface, including
metal.
• Drill two (2) 3/32-inch (2.5mm) holes approximately
1 inch deep for mounting the reader.
• Drill a 5/8-inch (16mm) hole for the cable.
• Remove the snap-on cover from the reader and
secure the reader to the mounting surface.
• Route the cable from the reader and/or power
supply to the host. A linear type power supply is
recommended. Check all electrical codes for proper
cable installation.
• For the cable connection to the Panel - Use Alpha
#1299C or equivalent.
• Test the operation of the reader. After completion of
the test, replace the snap-on cover.
• See sheet 3 of this manual for the appropriate
dimensioned drawings.
• For proper regulatory compliance, the drain wire
should be disconnected at the power supply end of
the cable.
• Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
• The Reader is intended to be powered from a
limited power source output of a previously certified
2 Connecting the Reader to the
Host
Connect the reader to the host according to the wiring
table below and the host installation guide.
Signal
Color
Signal
Color
9-14 VDC
Red
Beeper
Yellow
GND
Black
HOLD
Blue
D0
Green
CARD PRES
Violet
D1
White
RX
Pink
GRN LED
Orange
DTR
Gray
RED LED
Brown
TX
BLU/WHT
SHLD GND
Drain
3 Testing and Operation
• When power is applied to the reader the beeper
will beep once then the LED will flash green once