User's Manual

_________________________________________________________________________________________
HID Corporation 9292 Jeronimo Road Irvine, CA 92618 USA TEL [phone] [phone] FAX [phone]
Web page –
www.proxtrak.com
– ProxTrak Portal Reader Installation Procedure 6042-901-01 Rev 7
20 of 32
7.3 EEPROM Memory map table
Hex Dec Name Description Default
$00 - $27 000 -
039
FT 40 Reserved, 32 used, 8 spare Factory table - Exciter
$28 040 Red Red LED Duration byte $10 - 1.6 Sec (.4 Sec if
"fast" switch is on)
$29 041 Green Green LED Duration Byte $10 - 1.6 Sec (.4 Sec if
"fast" switch is on)
$2A 042 Beeper Beeper Duration Byte $10 - 1.6 Sec (.4 Sec if
"fast" switch is on)
$2B 043 Relay1 Relay 1 Duration Byte $10 - 1.6 Sec (.4 Sec if
"fast" switch is on)
$2C 044 Relay2 Relay 2 Duration Byte $10 - 1.6 Sec (.4 Sec if
"fast" switch is on)
$2D 045 Reserved
$2E 046 Reserved
$2F 047 Failsafe
activation
time
Number of seconds before Failsafe
activation after Comm failure
$1E - 30 Seconds
$30 - $32 048 -
050
Power up
Indicator
3 bytes to describe the indicator
status on Power-up
$E4 $55 $00; Two Med Red
Flashes off, Two Med Green
Flashes on, Two Med Beeps
on, Relays off
$33 - $35 051 -
053
Access read
indicator
3 bytes to describe the indicator
action on an Access Control Read
$02 $23 $88; Short Red
Flash off, Short Green Flash
off, Med Beep on, Relays no
change
$36 - $38 054 -
056
ProxTrak
read Indicator
3 bytes to describe the indicator
action on an Asset tag Read
$02 $33 $88; Short Red
Flash off, Short Green Flash
on, Short Beep on, Relays
no change
$39 - $3B 057 -
059
Host Tag
command
performed
3 bytes to describe the indicator
action when a ProxTrak command
has been executed from the Host
$AC $0D $88; Three Med
Red Flashes off, Three
Green Med Flashes on,
Three Med Beeps, Relays
no change
$3C - $44 060 -
068
9 Reserved, 0 used Spares
$45 069 Switch Block
2 Read and
Report
b0: Set Tamper Latch (Disable
Assets mode) on
b1: Re-report ID's
b2: Indicator re-report
b3: Fast indicators
b4: Acquisition test reports
b5: EEP database
b6: LCD reports
b7: Test LCD installed
$00; Read and Report
options - (Mirror of Switch
Block 2)
$46 070 Switch Block
3 Serial
Configuration
b0: Simplex Serial Output
(1 = on, 0 = Off)
b2 - b1: Baud Rate
11 = 4800 01 = 9600
10 = 38,400 00 = 19,200
b7 - b3: Node Address
(00000 - 11111)
$00; Serial Configuration;
(Mirror of Switch Block 3)