Installation Manual

HID Corporation 9292 Jeronimo Road Irvine, CA 92618 USA TEL [phone] [phone] FAX [phone]
Web page, E-mail - www.prox.com AMR100 Property Pass Reader Installation Manual 6015-900 REV A 4 of 6
Switch 4
Initialization Settings
On Off
1
Switch Over-ride
*
2
Reset Factory Defaults
*
3
EEPROM Unlock
*
4
Flash Mode Bit 0
*
5
Flash Mode Bit 1
*
Not Used *
Not Used *
Not Used *
Switch 3
Hardware settings
On Off
1
MaxiTrak mode
*
(Must remain in ON position)
2
Access Control Exciter
*
(Must remain in ON position)
3
Free-Running Acq
* ID acquisition is free running;
asynchronous with Host polls
4
Staus LED's Disable
*
(Must remain in ON position)
5
Hardware Demodulator
*
(Must remain
in OFF
position)
6
Low Gain
*
(Must remain
in OFF
position)
7
8 Receivers (Not Used)
*
(Must remain
in OFF
position)
8
2nd Access Reader
(Not Used)
*
(Must remain
in OFF
position)
Jumper Settings
There are several configuration options available according to how the jumpers are set on the board. These jumpers control
serial input and output selections, beeper and tamper switch settings. Refer to the table on the following page for appropriate
jumper settings.