User's Manual

__________________________________________________________________________________________________________
HID Corporation, 9292 Jeronimo Road, Irvine, CA 92618-1905, USA •Tel: [phone], Fax: [phone]
http://www.hidcorp.com MaxiProx Reader Installation Manual 5375-900 REV 06
Page
4
2.8
2.8 2.8
2.8 DipSwitch and Jumper Settings
DipSwitch and Jumper Settings DipSwitch and Jumper Settings
DipSwitch and Jumper Settings
Verify the default settings according to the model ordered, or set the DIPswitches and Jumper positions
according to the following.
Table 3: DIPSwitch and Jumper Settings
Switch Default Description
1. Interface mode 1 On See mode chart table 6 below
2. Interface mode 2 On See mode chart table 6 below
3. Interface mode 3 On See mode chart table 6 below
4. Beeper control On/Off On On - beep after valid card read. Off - no beep after valid card read.
5. Green LED flash Off Off - flash after valid card read. On - no flash after valid card read.
6. Single/Dual external LED Off Off - single line LED control. On - dual line LED control.
7. Serial Baud 1 control Off See baud rate chart below.
8. Serial Baud 2 control Off See Baud rate chart below.
Table 4: Interface Jumpers Description - P3 and P4
P3 and P4 1-2 See mode chart table 6 below
Table 5: Switch Description - SW2
Switch Default Description
1. Serial Baud 3 control On See baud rate table 7 below
2. Note address 0 N/A Unused
3. Note address 1 N/A Unused
4. Note address 2 N/A Unused
5. Note address 3 N/A Unused
6. Note address 4 N/A Unused
7. Unused
8. Unused
Table 6: Mode Chart
Mode SW1-1 SW1-2 SW1-3 SW5-3 SW5-4 SW5-5
P3 & P4
Jumpers
Wiegand ON ON ON NA NA NA 1-2
Clock & Data OFF ON ON NA NA NA 1-2
RS232 ON OFF ON NA OFF OFF 2-3
RS422
terminated
OFF OFF ON ON OFF OFF 2-3
RS422
unterm.
OFF OFF ON OFF OFF OFF 2-3
Table 7: Baud Rate Chart – RS232 and RS422
BAUD SW1-7 SW1-8 SW2-1
9600 ON ON ON
4800 OFF ON ON
2400 ON OFF ON
1200 OFF OFF ON