User's Manual

ENTRYPROX – 4045-907 REV A
52
PROGRAMMING A CARD OR CODE TO INITIATE
A TRANSACTION LOG REPORT “DUMP”
1. Place the EntryProx unit in program mode. Press:
99 # Master Code * (default is 1234)
2. For a CODE DUMP, press:
50 # 2 # user location # code * code *
For a CARD DUMP, press:
50 # 2 # user location # ** <present card>
and then present the card at the proximity reader.
3. Press * to exit program mode.
NOTE: Entering the programmed PIN code or
presenting the card subsequently causes the unit to
download a Transaction Log to the optional PDA.
DOWNLOADING A TRANSACTION LOG MANUALLY
1. Place the EntryProx unit in program mode. Press:
99 # Master Code * (default is 1234)
2. Hold the IR Port on the optional PDA up to the
EntryProx IR port steadily (about ½ inch away; the
IR port is located to the right of the yellow LED).
3. Start the DCD program on the Palm PDA, then
touch Retrieve
on the PDA
4. Then, on the EntryProx, press
70 # 0 # 0 # **
The PDA will display a progress bar while collecting
the data, and when done will display End of Dump.
You can touch Close/Stop on the PDA or wait for
the unit to time out. When prompted for a Session
Name,
you can place your stylus on the line
containing the date information and add to it or
replace it with descriptive text.
3. Press * to exit program mode.
The 70 command is logged in the transaction buffer
(in memory), providing a reference as to when
the log was downloaded. Figure 18 shows a sample
Transaction Log.