User's Manual

ENTRYPROX – 4045-907 REV A
38
PROGRAMMING COMMAND TABLE
Read the following table before completing programming of
your EntryProx unit; it describes various programming
commands and how to execute them. As with the previously
described commands, you must first press 99 # (Master
Code) * to
enter programming mode, enter the desired
command sequence, and then press * to exit programming
mode. “Ref” number is for reference only, not to provide an
ordered sequence of commands.
TABLE 2: PROGRAMMING COMMANDS.
TO...
Ref IF YOU WANT TO PRESS DETAILS
1 Enter program
mode
99 # (Master
Code) *
yellow LED
blinks slowly
2 Change master
code Code-only
operations
1 # (new code) *
(repeat code) *
example; 4321
master code
(1 # 4321 *
4321 *)
3 Set main relay time 11 # tt # 0 # ** tt = 1 - 99
seconds
4 Set AUX relay
output
15 # output mode
# 0 # **
Output Modes:
0 = disabled,
1 = shunt,
2 = forced door,
3 = propped
door
5 Delete users User Location #
**
Example:
To delete user
100, press:
100#**
6 Print a transaction
Log
70 # 0 # 0 # ** Hold optional
printer with
IR receiver near
the EntryProx IR
LED.