User's Manual

HID CORPORATION

WIEGAND MODE

If you program the EntryProx unit to operate in Wiegand

mode with a separate access control panel, the following

features are not accessible:

• The EntryProx unit does not control door lock or

unlocking

operations.

• The EntryProx unit is not able to store codes in memory.

• The main and auxiliary relay functions are turned off.

• The door monitor and Request to Exit inputs are disabled.

For more information on programming the EntryProx unit

for Wiegand operation, please contact your local distributor.

PIN CODE OUTPUT IN WIEGAND MODE

The system transmits keypad PINs while operating in

Wiegand mode by processing any digit sequence terminated

with the [*] key as 26-bit Wiegand data. The current facility

code (set using Code 32 - 2) will be used. Entering any PIN

over 65535 will cause an error condition and no data will be

sent.

Because keypad data is sent in a card data format, it may not

be possible for some panels to perform CARD AND CODE

operation (requiring both) to gain access. If your panel cannot

accept and interpret 26-bit format as PIN data, be sure to

configure the user at the PC host software by entering the

code into the CARD data field for that user, not the keypad

PIN number field.