User's Manual

HID CORPORATION
33
DELETING USERS
To delete a user from the EntryProx, you must know the
User Location in which the information is stored.
1. Place the EntryProx unit in program mode. Press:
99 # Master Code * (default is 1234)
2. On the EntryProx keypad, press:
user location #**
3. Press * to exit program mode.
BLOCK DELETE USERS
Use Command 58 to delete all cards / PINs in a block of
User Locations. The yellow LED will blink rapidly during
the deletion process. It can take several seconds to delete
large blocks of users. The following items will generate a
programming error:
Entering a starting User Location of 1 or greater than
2000
Entering a total number of locations which exceeds
1999
Entering a starting user location and number of
locations which exceeds 2000
To block delete user locations, follow these steps:
1. Place the EntryProx unit in program mode. Press:
99 # Master Code * (default is 1234)
2. On the EntryProx keypad, press:
58 # start location # start location # number of
locations * number of locations*
3. Press * to exit program mode
CHANGING THE MASTER CODE
Use the Quick Program Feature to change the master code
1. Place the EntryProx unit in program mode. Press:
99 # Master Code * (default is 1234)
2. On the EntryProx keypad, press:
1 # (new code) * (repeat new code) *
3. Press * to exit program mode