User's Manual

ENTRYPROX – 4045-907 REV A
32
If the Batch Loading conditions can be met:
1. Place the EntryProx unit in program mode. Press:
99 # Master Code * (default is 1234)
2. On the EntryProx keypad, press:
56 # (total number of cards to be added) #
(starting user location) # card number *
repeat card number *
NOTE: Never enter one (1) as the starting user
location since it is reserved for the master code.
3.Press * to exit program mode.
.
BATCH LOAD BY PRESENTATION
Use Command 53 to program a batch of cards into
consecutive User Locations by specify the starting User
Location, then presenting cards or tags to the reader. Use
any card format up to 37 bits. All cards are programmed
alike and users are “card only.” Card enrollment stops once
the current user location exceeds 2000, or press any key to
abort. Keep a written record as you program cards.
Existing data in the User Locations being programmed is
overwritten, unless you present a card that is already
programmed into the EntryProx, in which case an error is
generated. To clear the error, press the * key; then continue
presenting cards. If you enter User Location 1 as the first
card in the sequence, this will generate an error.
To batch load by presentation, follow this procedure:
1. Place the EntryProx unit in program mode. Press:
99 # Master Code * (default is 1234)
2. On the EntryProx keypad, press:
53 # user type # start location # ** <present
card> <present card>
<present card>…
3.
Press * to exit program mode.
USER TYPES - REMINDER
0-Toggle 1-Normal 2-Dump 3-Lockout